Lantronix SLPV1611E-02 Uživatelská příručka stáhnout pdf (Strana 58)

3: Operations

Example

The following command adds the descriptive name Florida__HQ_1 to tower .a:

SLP: set tower name .a Florida_HQ_1<Enter>

Displaying Tower information

The Show Towers command displays information about the SLP. This information

includes the absolute and descriptive SLP names.

To display unit information:

1. At the command prompt, type show towers and press Enter.

Example

SLP: show towers<Enter>

Tower Tower

ID Name

.A Florida_HQ_1

Displaying the firmware version

The Version command displays the firmware version.

To display the firmware version:

1. At the command prompt, type version and press Enter.

Performing a warm boot

The Restart command performs a warm boot of the unit.

Note: System user/outlet/group/port configuration or outlet states are NOT

changed or reset with this command.

To perform a warm boot:

1. At the command prompt, type restart and press Enter.

TCP/IP Administration

Note: A restart of the unit is required after setting or changing any TCP/IP

configurations.

Enabling or disabling DHCP support

The Set DHCP command enables or disables DHCP support.

To enable or disable DHCP support:

1. At the command prompt, type set dhcp, followed by enabled or disabled and

press Enter.

Setting the IP address

The Set Ipaddress command sets the TCP/IP address of the network interface

controller.

To set the IP address:

SecureLinx SLP Remote Power Manager 57

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 108 109

Žádné komentáře

Lantronix SLPV1611E-02 Uživatelská příručka Strana 58