Lantronix EDS1100 Uživatelská příručka stáhnout pdf (Strana 59)

8: Line and Tunnel Settings

EDS1100/2100 User Guide 58

3. Click Submit.

Multiple Hosts

When you configure two or more hosts in the Tunnel web page, Host Mode displays as shown in

Figure 8-18.

Reconnect Timer Enter the reconnect time in milliseconds. The EDS1100/2100 attempts to

reconnect after the specified amount of time when a connection fails or when

exiting an established connection. This behavior depends upon the

Disconnect Mode.

Notes:

 When you configure Tunnel - Connect Mode, you can specify a

number of milliseconds to attempt to reconnect after a dropped

connection has occurred. The default is 1500 milliseconds.

 The Reconnect Timer only applies if a Disconnect Mode is configured.

With a Disconnect Mode set, the device server maintains a connection

until the disconnect mode condition is met (at which time the device

server closes the connection). If the tunnel is dropped due to conditions

beyond the device server, the device server attempts to re-establish a

failed connection when the specified reconnect interval reaches its limit.

 Any network-side disconnect is considered an error and a reconnect is

attempted without regard to the Connect Mode settings. Simultaneous

Connect Mode connections require some Disconnect Mode

configurations or the connections will never terminate. See Disconnect

Mode on page 61

for more information about the parameters.

 If Disconnect Mode is disabled and the network connection is dropped,

then the re-establishment of a tunnel connection is governed by the

configured Connect Mode settings.

Flush Serial Data Select whether to flush the serial line when a connection is made. Choices

are:

 Enabled—Flush the serial line when a connection is made.

 Disabled—Do not flush the serial line. This is the default.

Block Serial Data Select On to block (not tunnel) serial data transmitted to the EDS1100/2100.

Block Network Data Select On to block (not tunnel) network data transmitted to the EDS1100/

2100.

Email on Connect Select whether the EDS1100/2100 sends an email when a connection is

made. Select None if you do not want to send an email. Otherwise, select the

Email profile to use.

Email on Disconnect Select whether the EDS1100/2100 sends an email when a connection is

closed. Select None if you do not want to send an email. Otherwise, select

the Email profile to use.

CP Output Identifies a CP or CP Group whose value should change when a connection

is established and when it is dropped.

Table 8-17 Tunnel Connect Mode Fields (continued)

Field Description

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 156 157

Komentáře k této Příručce

Žádné komentáře

Lantronix EDS1100 Uživatelská příručka Strana 59

Komentáře k této Příručce

Související produkty a manuály pro Sériové servery Lantronix EDS1100